30
en | (Optional) Installing the Illuminator
5. Align the illuminator over the access port and carefully push into position on the camera
head.
6. Partially engage the threads of all three (3) screws. Do not tighten any one screw
completely at this point.
–
Warning!
Total engagement is not complete until you tighten all three (3) screws.
!
2019-11 | 2.1 |
B
A
A
B
C
A
B
C
A
B
C
Using the T20 Torx driver, tighten the screws to the proper torque using the sequence
described in the previous figure.
C
0 - 0.7 N m
0.7 - 1.4 N m
1.4 N m
Installation Manual
MIC IP starlight 7000i
Bosch Security Systems