DEC VAXmate Service Manual page 143

IIIII
FRU Replacement
4. Make sure the spring clip and two pivots are installed correctly.
NOTE
The spring clip must be halfway into the channel so that the screen
is at mid-position, prepared for bezel attachment.
5. Attach the bezel as follows. Make sure the power LED does not catch on
the inside.
a. Insert the left bezel screw.
b. Insert the three screws under the bezel.
c. Insert the diskette drive mounting (top) screw.
6. Attach the power LED cable to the CPU board.
7. Tilt the CRT assembly to its lowest position.
8. With the CRT neck at its highest position, connect the 9-wire filament
connector to the neck of the CRT.
9. Make sure to secure the wires to the neck of the CRT by fastening a tie-
wrap around them.
10. Connect the white ground lug cable.
11. Connect the 4-pin cable to the monitor board.
12. Connect the monitor board to the I/O-video and power supply boards.
13. Insert the screw that holds the monitor board to the CRT.
14. Insert the anode connector in the CRT anode hole.
15. Secure the anode wire to the CRT.
16. Attach the two braided ground straps to the CRT shield.
17. Attach the spring to the spring mount.
18. Attach the webbed shield to the CRT shield.
5-32