FRU Replacement
11111
14. Remove the CRT bezel as follows.
a. Use the tilt bar
to
tilt the screen to its highest position.
b. Slide the system unit to the edge of the table.
c. Remove the three screws on the underside of the front bezel.
d. Remove the left bezel screw (Figure 5-23).
e. Use the tilt bar to reposition the screen to its normal level.
f. Push the system unit back to the center of the table.
g. Remove the diskette drive mounting screw (top) from the diskette
drive housing (Figure 5-23).
h. Lift the bezel away from the CRT.
DISKETTE DRIVE
MOUNTING SCREW
BEZEL
~
~'~~'-
~l(-'
4
~-
"'~ ~~,
D
~
.
,
!
........ --1.....,.-
I
A
I
A
LJ·0930
Figure 5-23
Removing the Four Bezel Screws and the Top Screw
5-29