Table of Contents
Advertisement
Note
In the case of screens without warning or information texts, faults are indi-
cated exclusively by the warning lamps.
Warning reports, Priority 1 (red)*
If one of these faults occurs, the warning lamp will flash or light up and will
be accompanied by three audible warnings. This is a danger warning. Stop
the car and switch off the engine. Check the fault and correct it. Obtain profes-
sional assistance if necessary.
If several priority 1 faults are detected at the same time, the symbols will be
displayed one after the other for about 2 seconds at a time and will continue
until the fault is corrected.
No menus will be shown in the display for the duration of a priority 1 warning
report.
Examples of priority 1 warning reports (red)
•
Brake system symbol
SERVICE MANUAL or STOP BRAKE FAULT SERVICE MANUAL.
•
with the warning text STOP SEE COOLANT SERVICE
Coolant symbol
MANUAL.
•
Engine oil pressure symbol
PRESSURE LOW! SERVICE MANUAL.
Warning reports, Priority 2 (yellow)*
If one of these faults occurs, the warning lamp lights up, and is accompanied
by one audible warning. The function should be checked as soon as possible.
Safety First
with the warning text STOP BRAKE FLUID
with the warning text STOP ENGINE OIL
Operating instructions
If several priority 2 warning reports are detected at the same time, the
symbols are displayed one after the other for about 2 seconds at a time. After
a set time, the information text will disappear and the symbol will be shown
as a reminder at the side of the display.
Priority 2 warning reports will not be shown until all Priority 1 warning
reports have been dealt with!
Examples of priority 2 warning reports (yellow):
•
Fuel warning light with the information text PLEASE REFUEL.
•
Windscreen washer fluid symbol
WINDSCREEN WASHER FLUID. Refill the windscreen washer tank
⇒ page 222.
6)
Depending on the version of the model.
Practical tips
Cockpit
6)
with the information text REFILL
Technical Data
63
Advertisement
Table of Contents
