Table of Contents
Advertisement
Recommended gear display*
This display helps to save fuel.
Use the gear display to save fuel. If you are driving in the correct gear, a dot
will be shown next to the gear display. If you are not in the correct gear, an
arrow will appear next to the gear display indicating whether you should
change up or down.
Mileage display or Service Interval Display
Distance display
The left-hand counter in the display registers the total amount of distance
covered by the vehicle.
The right-hand counter registers the short journeys. The last digit indicates
steps of 100 metres. The trip recorder counter may be reset by holding down
⇒ page 55, fig. 33
the reset button
Safety First
Fig. 38 Gear display
A
for a few seconds.
6
Operating instructions
Service interval display
A Service pre-warning will appear in the mileage displays if a service is due
soon. A "spanner" symbol appears and the display "km" with the distance
that can be driven until the next service appointment is due. The display will
change after approximately 10 seconds. A "clock symbol" appears and the
number of days until the service appointment should be carried out. The
following message is shown in the instrument panel display: SERV. IN... KM
OR... DAYS. The service message will disappear approximately 20 seconds
after the ignition is switched on or the engine is running. The normal display
can be resumed by pressing the reset button on the trip counter or by
pressing the rocker switch of the MFI
With the ignition switched on, you can call up the current service message by
pressing the trip counter reset knob for 2 seconds.
An overdue service is indicated by a minus sign in front of the mileage or day
information.
Practical tips
Cockpit
⇒ page 60, fig. 39
A
.
B
Technical Data
59
Advertisement
Table of Contents
