Commissioning The Hmi Device; Overview; Transferring A Project - Siemens SIMATIC HMI Series Getting Started

Commissioning the HMI device

4.1

Overview

To transfer the migrated project from the configuration PC to the Comfort HMI device,
connect the Comfort HMI device with one of the following interfaces on the configuration PC:
● Ethernet
● USB
● PROFIBUS/MPI
After successful transfer, you can insert the system memory card in the Comfort HMI device
and activate automatic backup as part of the service concept.
In the event of a fault, it is usually sufficient to restart the device or update the operating
system. Resetting to factory settings ("bootstrapping") is only necessary in case of serious
errors, for example, in case of a corrupt file system.
4.2

Transferring a project

NOTICE
Note the information regarding connection of an HMI device to a configuration PC in the
operating instructions of the Comfort HMI device.
The project transfer is shown based on a USB connection.
Requirements
A project with configured Comfort HMI device is open in WinCC.
Migration Guide Comfort Panels
Getting Started, 03/2011, A5E03478626-01
4
43