Disabling Or Enabling Post - Juniper LN1000 User Manual

LN1000 Mobile Secure Router

Disabling or Enabling POST

38
Secondary Loader1: UP TO DATE
IPMC Firmware: UP TO DATE
IPMC_RB Firmware: UP TO DATE
Hit any key to stop autoboot:
IPMC test
IPMC test completed, 1 pass, 0 errors, 0 warnings
BOOT >
After pressing the space bar, the process continues performing some system tests,
3.
and then the boot process stops at the
For available commands, enter
4.
Disabling POST
To disable the POST feature:
BOOT> setenv no_run_post 1
BOOT> saveenv
BOOT> reset
NOTE: Only the first character of the environmental variable is evaluated. If
the variable is not set, or if the first character of the variable's value is zero
(0), then the default behavior for POST (runs automatically) and file system
cleanup (not performed) is followed.
When you disable POST, the standard set of POST diagnostic tests are skipped. The
following sample console output shows that the POST feature is disabled:
....
NVMRO: Write-enabled
watchdog: Armed
FPGA: Enabled
FS Cleanup: Disabled
POST: Disabled
Firmware Image Status:
Primary Bootstrap: UP TO DATE
....
IPMC test completed, 1 pass, 0 errors, 0 warnings
Skipping POST
Booting...
Enabling POST
To enable the POST feature and run the full set of POST diagnostic tests during the
boot-up process:
1
prompt.
BOOT>
or at the prompt.
help ? BOOT>