Ln1000 Mobile Secure Router Features; Router Backplane Connector; Ethernet Ports; Ipmi Interface - Juniper LN1000 User Manual

LN1000 Mobile Secure Router Features

Router Backplane Connector

Ethernet Ports

IPMI Interface

Router Console Port

The LN1000 Mobile Secure Router provides the following features:
Router Backplane Connector on page 5
Ethernet Ports on page 5
IPMI Interface on page 5
Router Console Port on page 5
Tamper-Evident Seals on page 6
An external interface, located on the back of the LN1000 router, connects the router to
the VITA 46.0–compliant chassis. The router's P0, P1, and P2 connectors plugging into
the backplane are VITA 46.0–compatible for a 3U peripheral slot with specific key
definitions. The P0 and P2 connectors are keyed per the VITA 46.12 specification. Power
to the LN1000 router is provided through the P0 connector.
The LN1000 router supports up to eight ports of gigabit Ethernet traffic with up to 1024
logical interfaces. The router supports most Layer 2 and Layer 3 protocols, route
redistribution, tunneling, multicast, routine quality of service (QoS), and security.
The eight gigabit Ethernet ports on the LN1000 router are 1000Base-X interfaces with
autonegotiation on by default. The Ethernet ports on the router interface with the chassis
in which it is installed or with the LN1000 rear transition module, if installed in a chassis.
The LN1000 router supports the Intelligent Platform Management Interface (IPMI) in
accordance with the VITA 46.0 specification. The IPMI controller on the LN1000 router
is a secondary controller while the IPMI Shelf Manager operates as the primary controller.
The IPMI Shelf Manager is not supplied by default; it is available as an option.
The router's RS-232 console port has a baud rate of 9600 8N1 and is located on the left
side of the LN1000 router's front panel. The console port is used primarily for depot repair.
It is covered by a protective aluminum plate that prevents access to the port. When the
LN1000 router is operational and installed in a chassis, even though you can remove the
protective aluminum plate to access the console port on the router, typically you access
the console port using one of the following methods:
On the chassis backplane when the router is installed in VITA 46.0-compliant chassis
On the front panel of the rear transition module when the router is installed in a VITA
46.0-compliant chassis with a LN1000 rear transition module
Chapter 1: LN1000 Router Overview
5