EUFY RoboVac Owner's Manual
Hide thumbs
Also See for RoboVac:
- User manual ,
- Owner's manual (58 pages) ,
- Quick start manual (11 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for EUFY RoboVac
Summary of Contents for EUFY RoboVac
- Page 1 Owner’s Manual RoboVac 51005001572 V01...
-
Page 2: Table Of Contents
• The used battery should be placed in a sealed plastic bag and disposed of safely according to local environmental regulations. Thank you for purchasing RoboVac. Read all instructions before using • The external flexible cable or cord of the power supply this product, and keep it properly for future reference. - Page 3 power supply unit shall be disposed of. • Do not handle plug or appliance with wet hands. • This device is for indoor use only. Do not use outdoors or • Do not use without dust bag and/or filters in place. on wet surfaces.
- Page 4 void the user's authority to operate the equipment. type T2117/T2118/T2120/T2123/T2128/T2130 is in compliance with Directive 2014/53/EU. The full text Note:This equipment has been tested and found to of the EU declaration of conformity is available at the comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
- Page 5 appareil et comprennent les risques encourus, et l'utilisent d'eau de javel, de peinture, de produits chimiques ou quoi dans un endroit sûr. que ce soit de mouillé. • Les enfants doivent être surveillés afin de s'assurer qu'ils ne • Avant d'utiliser cet appareil, ramassez les objets tels que jouent pas avec cet appareil.
-
Page 6: About Your Robovac
About Your RoboVac température supérieure à 130°C peut provoquer une explosion. • Ne modifiez pas et n'essayez pas de réparer l'appareil ou What's In the Box la batterie (si applicable), sauf si cela est indiqué dans les instructions d'utilisation et d'entretien. -
Page 7: Robovac Anatomy
RoboVac Anatomy C. Dust Collector Filter A. Top & Side Wi-Fi status light Auto cleaning Start/Stop button Bumper D. Suction Inlet Infrared sensor Dust collector Dust collector Dust collector release button B. Bottom Charging contact pins Drop sensor Suction inlet... -
Page 8: Led Indication
Flashing / Solid red + Keep RoboVac away from wet areas. Refer to the “Troubleshooting>Error Tone” section in this Beeping manual for solutions. RoboVac may climb on top of objects less than 0.63 in/16 mm in height. Remove these objects if possible. -
Page 9: Preparation
• RoboVac has a pre-installed rechargeable battery that has to be fully charged before use. • RoboVac returns to the Charging Base at the end of a cleaning cycle or when its battery is running low. -
Page 10: Use Your Robovac With The Eufyhome App
Solid blue Connected to your wireless router Turn off the main power switch if RoboVac will not be used for a long period of - If you have any problems during the Wi-Fi setup process, refer to the time. To preserve the battery’s lifespan, recharge at least once every 6 months. -
Page 11: Start / Stop Cleaning
Sunday to Saturday on the EufyHome app. This function is available in the app only. Start / Stop Cleaning • Make sure the main power switch on the bottom of RoboVac is turned on before use. • You can also start or stop cleaning via the EufyHome app. - Page 12 You can direct RoboVac to clean a particular area by using the directional buttons on the remote control. RoboVac reduces its speed when it detects a wall and then follows the wall to ensure the edge is cleaned thoroughly. In Edge mode, RoboVac will clean for 20 minutes and return to the Charging Base.
-
Page 13: Use Your Robovac With Amazon Alexa / The Google Assistant
Before you start, make sure that: Filter (Twice a week if you Every 2 months • RoboVac is attached to the Charging Base to ensure there is enough power. have a pet) • RoboVac is connected with the EufyHome app. Rolling Brush... -
Page 14: Clean The Rolling Brush
Clean the Rolling Brush Take out the filter. Pull on the release tabs to unlock the brush guard as shown. Lift the rolling brush to remove. Clean the rolling brush with the provided cleaning tool or a vacuum cleaner. Reinstall the rolling brush by inserting the fixed protruding end first and then clicking into place. -
Page 15: Replace The Side Brushes
Clean the Sensors and Charging Pins Use a cloth dampened with warm water to remove dust from the brushes or to gently reshape them. To maintain the best performance, clean the drop sensors and charging pins regularly. • Dust off the drop sensors and charging contact pins using a dry cloth or cleaning brush. -
Page 16: Troubleshooting
Google Assistant. charged. to the Google Assistant. When making your request, first • Check if you can hear a beep when RoboVac is docked say the wake words “Ok Google”. onto the Charging Base. If not, contact the eufy service •... - Page 17 Wi-Fi Connection Error Tones When RoboVac is in trouble, it will emit a series of short or long beeps and the red Before Wi-Fi setup, make sure RoboVac and your Wi-Fi network meet the following indicator on RoboVac will be solid or flashing.
-
Page 18: Specifications
RoboVac cannot Rapidly • Reset Wi-Fi connection if necessary. connect to your wireless flashing blue Refer to the “Use Your RoboVac with router. the EufyHome App > Restore Factory Settings” section in this manual. @EufyO cial @EufyO cial...
Need help?
Do you have a question about the RoboVac and is the answer not in the manual?
Questions and answers
can I move the charging base between two different floor levels? (and then have a map for each level)
Yes, the EUFY RoboVac charging base can be moved between two different floor levels. When the “Multi-map Saving” function is enabled, the RoboVac X8/X8 Hybrid can create a new map without overwriting the existing one. To do this, bring both the RoboVac and its charging base to the new floor and follow the setup steps.
This answer is automatically generated