EUFY RoboVac Quick Start Manual

Quick Start Guide

Using Your RoboVac

Remove the sticker on the power switch, and the foam blocks beside the bumper before use.
If you cannot remove the objects surrounding the Charging Base, check whether RoboVac
can return without assistance; if not, contact eufy customer service for help.
- Always keep the Charging Base plugged in, Fully charge RoboVac before
otherwise RoboVac will not automatically return. use. The LED indicator on the
- When the Charging Base connects to AC power,
while charging, and turns solid
the LED indicator on the Charging Base is SOLID
blue when fully charged.
WHITE.
Download the EufyHome app and follow
the instructions in the app to complete the
EufyHome
Wi-Fi connection. Then you can control
EufyHome
RoboVac via this app. Refer to the Owner's
Manual for details.

Mopping

ON
Do not use the mopping mode on a
carpeted floor.
button breathes orange
01

Important Tips

When using for the first time, follow RoboVac to observe and resolve any problems that may occur.
Wet the cloth before mopping.
Remove power cords and small objects from the floor that may entangle RoboVac. You can use
the supplied cable ties to organize your wires and power cords.
Fold tasseled edges of area rugs underneath to prevent tangling RoboVac. Avoid cleaning very
dark-colored high-pile rugs or rugs thicker than 1.02in / 26mm as they may cause RoboVac to
malfunction.
It is strongly recommended to place boundary strips in front of fireplaces and certain areas (i.e.
air vents) that may cause damage to RoboVac if entered.
Keep RoboVac away from wet areas during cleaning.
RoboVac may climb on top of objects less than 0.63in / 16mm in height. Remove these objects
if possible.
Anti-drop sensors will prevent RoboVac from tumbling down stairs and steep drops in most
cases. Sensors are less effective if dirty or used on carpeted/reflective/very dark-colored floors.
It is recommended to apply the Boundary Strip(s) to block off areas where RoboVac may fall.
To keep RoboVac away from any area or item you do not want RoboVac to clean, apply the
Boundary Strip(s) on the floor with adhesive tape to create a virtual barrier. Make sure the
strips are placed FLAT on the floor.
24
h
8
02
1
2
51005002509 V01
03