Camera; Gimbal; Compass - dji PHANTOM 4 RTK Disclaimer And Safety Manuallines

5. Repair or replace the remote controller if damaged. A damaged remote controller antenna will greatly decrease
performance.
6. Replacement remote controllers have to be linked to the aircraft. Linkage is only considered safe if through testing
the transmission distance can reach 300 meters. Refer to the User Manual for details.
7. The remote controller uses a removable Intelligent Battery. Refer to the WB37 Intelligent Battery Safety Guidelines
for usage instructions and safety warnings.
8. Upon linking an aircraft to a remote controller, any link the aircraft previously had to any other controller is
dropped. As such, all the aircraft linked to a controller that is in Multi-Aircraft Control mode can only be controlled
by that one controller. To control any of the aircraft using a different controller that aircraft must be manually linked
to the controller using the DJI GS RTK app.

Camera

To avoid possible serious injury and property damage, observe the following rule:
1. DO NOT block any ventilation holes on the camera as the heat generated may hurt you and damage the device.
1. Check camera settings before use to make sure you can adjust them to fit your needs.
2. Test the camera by shooting a few test images and check that it is operating correctly before shooting important
pictures or videos.
3. DO NOT remove the microSD card from the camera when it is powered on.
4. Photos or videos cannot be transmitted or copied from the camera if the Intelligent Flight Battery is powered off.
5. Be sure to power off the Intelligent Flight Battery correctly, otherwise your camera parameters will NOT be saved
and any recorded videos may be damaged. NOTE: Regardless of the reason, DJI will not be responsible for any
failure of an image or video to be recorded or having been recorded in a way that is not machine readable.

Gimbal

1. Precision elements in the gimbal may be damaged in a collision or impact, which may cause the gimbal to function
abnormally.
2. DO NOT apply external force to the gimbal after the gimbal is powered on.
3. DO NOT add any payloads to the gimbal, as this may cause the gimbal to function abnormally or even lead to
motor damage.
4. Remove the gimbal clamp before powering on the gimbal. Re-install the gimbal clamp to secure the gimbal's
position if you are going to store the aircraft for an extended period.

Compass

To avoid possible serious injury and property damage, observe the following rule:
1. Land immediately when obvious drifting occurs in flight, i.e., the aircraft does NOT fly in straight lines.
Only calibrate the compass when the DJI GS RTK app or the status indicator prompt you to do so. Observe the
following rules when calibrating your compass:
©
2018 DJI All Rights Reserved.
7