IBM AS/400e Manual page 63

__ 26. Look at the Function/Data display on the control panel. Does a B appear
in the Function/Data display?
Yes No
↓
Do the following:
a. Press the Up or Down select push button until 02 appears in
the Function/Data display.
b. Press the Enter push button on the control panel.
c. Press the Up or Down select push button until B appears in the
Function/Data display.
d. Press the Enter push button on the control panel.
e. Press the Up or Down select push button until 01 appears in
the Function/Data display.
f. Press the Enter push button on the control panel.
__ 27. Make sure that the IPL mode is in Manual mode. If it is not press, the
Mode button until a light indicates that Manual is the active mode.
__ 28. Power on the workstation or PC that is your system-unit console
__ 29. Press the power button to power on the AS/400 server.
__ 30. Do the following to verify your disk unit configuration:
__ 31. Do the following to verify your disk unit configuration:
a. When the IPL or install the System menu appears, select the Use
dedicated service tools option.
Press the Enter key.
b. On the Dedicated Service Tools (DST) Sign-On display, enter your DST
Userid and password.
Note: The default DST password is 22222222222, unless it has been
changed.
Press the Enter key.
c. When the Use Dedicated Service Tools menu appears, select the Work
with disk units option.
Press the Enter key.
d. When the Work with Disk Units display appears, select the Work with
disk configuration option.
Press the Enter key.
e. When the Work with Disk Configuration menu appears, select the
Display disk configuration option.
Press the Enter key.
f. When the Display Disk Configuration menu appears, select the Display
non-configured units option.
Press the Enter key.
Appendix C. Installing disk units in the 5065 or 5066 Expansion Unit
51