Connecting Your 5065 Expansion Unit In A Loop - IBM AS/400e Manual
Setting up your expansion unit
Hide thumbs
Also See for AS/400e:
- User manual (19 pages) ,
- User handbook manual (834 pages) ,
- Manual (46 pages)
Table of Contents
Advertisement
Figure 12. Install Back Cover
Connecting your 5065 Expansion Unit in a loop
Use this procedure to connect your 5065 to an expansion unit which is already
connected to your system unit. Your system unit should be powered down before
you proceed. If your system unit is not powered down, read "Powering down
your AS/400 system unit" on page 5 and power down your system unit.
To make this procedure simpler, refer to the other expansion unit as unit X, as is
shown in Figure 13.
Figure 13. Connecting your 5065 to another expansion unit
12
Setting Up Your 5065 or 5066 Expansion Unit V4R5
Advertisement
Table of Contents
