IBM AS/400e Manual page 60

__ 4. When you have completely powered down the system-unit, power off all
__ 5. Unplug any power cords, such as printers and displays, from electrical
__ 6. Unplug the system-unit power cord from the electrical outlet.
__ 7. Refer to Figure 33 on page 39 use the latch that is shown at A to open the
__ 8. If needed, use the latch that is shown at B to remove the front cover.
__ 9. Attach the disposable wrist strap to prevent electrostatic discharge from
__ 10. Attention: Disk units are fragile. Handle with care.
__ 11. Locate the next available position for the disk unit by reviewing the steps
__ 12. Find the package that contains the new disk unit assembly and remove it
__ 13. Write the serial number (SN xx-xxxxxxx) of the disk unit here
__ 14. Refer to Figure 37 on page 49 and remove the enclosure shield for the disk
48
Setting Up Your 5065 or 5066 Expansion Unit V4R5
PCs and devices, such as printers and displays, that are connected to the
system-unit.
outlets.
front cover.
damaging a device.
Notes:
a. Follow the same precautions you would use without the wrist strap.
The 2209 Disposable Wrist Strap is for static control. It will not increase
nor decrease your risk of receiving electric shock when using or
working on electrical equipment.
b. If the disposable wrist strap appears damaged, discard the wrist strap
immediately and contact your dealer for a replacement. Do not
continue until a new wrist strap is available.
c. When you unroll the strap, remove the liner from the copper foil at the
end.
d. Attach the copper foil to an exposed, unpainted metal surface on the
frame of the expansion unit (electrical ground).
Be sure to use the wrist strap provided. Place one end of the wrist strap
around your wrist and ensure that you connected the opposite end to the
expansion unit.
in "Optimizing your new disk unit" on page 37.
from the static-protective package.
______________ before you install it.
unit.