Chapter 2. Setting Up Your 5065 Expansion Unit; Connecting Your 5065 Directly To Your As/400E System Unit; Connecting The Cables To Your 5065 Expansion Unit - IBM AS/400e Manual

Setting up your expansion unit

Hide thumbs Also See for AS/400e:

Table of Contents

Chapter 2. Setting up your 5065 Expansion Unit

This chapter explains how to set up your 5065 Expansion Unit. This chapter has

two sets of directions:

v "Connecting your 5065 directly to your AS/400e system unit".

v "Connecting your 5065 Expansion Unit in a loop" on page 12.

Follow the direction that best fits your configuration.

Connecting your 5065 directly to your system unit consists of two major steps:

1. Connecting cables to your 5065 Expansion unit.

2. Connecting cables to your system unit.

Use the following steps to install the SPCN cables and optical cables to the 5065

Expansion Unit.

__ 1. Find the sheet of labels for the optical cables in the information shipped

__ 2. Find the optical cables and the SPCN cable in the information that is

__ 3. Attach a label to each end of the optical cables.

__ 4. Label one optical cable 0. Label the other optical cable 1.

Figure 6. Labeling the optical cables

__ 5. Use the latch that is shown at A to open the back cover on your

__ 6. If needed, use latch shown at B to remove the back cover.

with your expansion unit. (Make your own, if labels are not in the

information that is shipped with your expansion unit.)

shipped with your expansion unit.

expansion unit.

RV2D094-0

Table of Contents

5065 5066