__ 1. If you are installing your optical cables into an AS/400e system 620 or
AS/400e server 720 go to step 7. If you are installing your optical cables into
any other server, go to step 2.
__ 2. Locate the 2688 OLP card (Figure 11) on the back of your system unit.
Figure 11. 2688 OLP card
__ 3. Remove the terminating plugs from the optical card connectors.
__ 4. Push the optical cable that is labeled 0 into the top optical cable connector in
the system unit.
__ 5. Install the optical cable that is labeled 1(for the redundant link) from the
expansion unit into the bottom optical cable card connector.
__ 6. Go to 7f.
__ 7. If you are installing optical cables into an AS/400e system 620 or AS/400e
server 720 proceed as follows:
a. On the back of your system unit, locate the optical cable connectors that
have the following labels:
b. Choose the next available set of optical cable connectors.
c. Remove the terminating plugs from the optical cable connectors.
d. Install the optical cable that is labeled 1 into the even numbered optical
cable connector (BUS 06 or BUS 04).
e. Install the optical cable that is labeled 0 into the odd numbered optical
cable connector (BUS 05 or BUS 03)
Example: If the optical cable connectors that are available are BUS 06 and
BUS 05:
1) Install the optical cable that is labeled 1 into BUS 06.
2) Install the optical cable that is labeled 0 into BUS 05.
f. Install the system unit back cover (Figure 12 on page 12) by doing the
following:
__ 1) Grip the upper corners of the cover.
__ 2) Align the pins with the slots.
__ 3) Push the cover in and down.
__ 4) Go to "Chapter 5. Verifying Your New Configuration" on page 25.
BUS 06
BUS 05
BUS 04
BUS 03
Chapter 2. Setting up your 5065 Expansion Unit
11