Hydraulic Tank Installation - Tiger JOHN DEERE 5083E Assembly Instructions Manual

HYDRAULIC TANK INSTALLATION

Install all fittings and tubes into tank and tank filter as shown in the Parts Section
illustration. Insert tank sight glass into front side of tank.
Place the tank in the mounting bracket on the main frame as shown in the Parts
Section. Secure the tank with the tank channel mount by placing the channel mount on top of
the tank and the washers over the holes. Thread the tie bolts through the washers and holes
to the threaded holes on the main frame. Tighten the tank channel mount by using the hex
heads on the end of the tie bolts.
Install the filter gauge into the filter housing so that it points to the rear of the tractor
and is clearly visible to the operator. The tank breather cap is ready for use as the tank is
filled. Some of the for-metioned items may be already installed.
FILLING HYDRAULIC RESERVOIR
Refer to the maintenance section for filling specifications and hydraulic oil requirements.
(ASM-C-0004hydro resrv)
WHEEL SPACER WITH WHEEL WELL TANK
When the left wheel is off, a spacer kit is needed with the wheel well tank (part#
06200637.) Attach the spacer to the left wheel portion of the axle with the hardware
provided. When you are ready to re-attach the left wheel, the wheel goes on first then
the reinforcement ring and finally the hardware provided.
(ASM-JD-0070)
ASSEMBLY
Assembly Section 2-12
(ASM-MOTOR HYDRO-0001)