Installation And Operation; Installation - Bartscher PRO II 40T Manual

5. Installation and operation

5.1 Installation


Unpack the device and remove all package materials according to the valid
environment protection regulations.
CAUTION!
Never remove the nameplate and warning signs from the device.

Put the device on an even, stable, dry and waterproof surface which is resistant to
high temperature.

Never place the device on an inflammable surface.

Never put the device in a moist or wet area.

Never place the device at the edge of a table to avoid tilting or falling.

Do not place the device near open flame, electric heaters or other heat source.

Place the device so that the plug is easily accessible so as to quickly disconneet the
device if the need arises.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see rating plate). Connect the device only in case of
compliance!
Connect the device only to properly installed single
socket with protective terminal.

The electrical circuit in the socket must be secured to 16A. Only connect the device
directly to the wall socket; do not use any extension cords or power strips.
- 35 -