Bartscher PRO II 40T Manual page 21

CAUTION!
Do not leave the device unattended during descaling!
Use the protective gloves and goggles during descaling to protect yourself
from the descaling solution splashes.
o Descaling of the device should be realized according to the following instructions:
Dissolve the content of the bag (15 g) in approximately 5 litres of water.
-
Slide the riser pipe through the filter basket centre and place it in the water tank.
-
Make sure that the riser pipe has been carefully inserted in the heating bowl.
Pour the descaling solution into the water tank of the coffee machine. Put the lid
-
on the water tank and activate the device.
Perform the brewing cycle and leave the coffee machine on for next 15 minutes.
-
Then turn the device off and drain the descaling solution through the drain tap to
-
the suitable container.
- After descaling repeat the brewing cycle at least three times with use of clean
water to remove all residuals of the descaling solution.
Pour some fresh water into the tank and draiit to the suitable container through the
-
drain tap to rinse it.
Rinse the water tank, the riser pipe, the filter basket, and the lid thoroughly with
-
clean water.
Finally dry all cleaned parts and surfaces with soft cloth.
-
o After descaling the coffee maker must be turned on only after pressing the RESET
button in the base. The red descaling indicator will not come on after the device
activation.
o The coffee machine is ready for the operation again.
o Sash your hands thoroughly after descaling.
Storage of the device
o If the device is not used for any lengthy period of time, clean it according to the
aforementioned description and store it in dry, clean place protected against cold,
sun and children. Do not place any have objects on the device.
- 42 -