Blade Information
Important issues regarding blade perfor-
mance:
•
Scroll saw blades wear out and must be
replaced frequently. Typically a blade will
stay sharp anywhere from
depending on how the blade is used and
what type of material is being cut.
•
Best cutting results will be achieved when
cutting material less than 1" thick.
•
When cutting material thicker than 1", use a
very slow feed rate.
•
Blades will become dull quickly whenever
making cuts in plywood, hardwoods, and
laminates.
•
Exerting excessive side pressure on the
blade greatly increases the chance of blade
breakage.
Teeth Per Inch
Width Thickness Strokes-Per-Minute
10
0.110"
15
0.110"
18
0.095"
1
⁄
to 2 hours
2
Blade Selection Table
0.020"
1200-1600
0.020"
600-1200
0.010"
400-600
-17-
Blade Speed
To change the blade speed:
The blade speed is variable between 400 and
1600 strokes-per-minute (SPM). Blade speed
adjustments are made using the variable speed
/power knob (Figure 11) on the front of the
scroll saw.
Figure 11. Variable speed/power knob.
Material Being Cut
General purpose blade for cutting hard
and soft woods between
Also good for plastics, paper, felt, and
bone.
Good for cutting very thin wood and
plastic between
Good for tight radius cutting in thin
hard and soft woods between
1
⁄
". Also good for veneer, bone, ivory,
8
and plastics
3
⁄
" and 2".
16
3
⁄
" and
1
⁄
".
32
2
3
⁄
" and
32