Designated Use And Limitations To Use; Remaining Hazards - Jet Elite EVC-400DGSP Manual

3.1 Designated use and limitations to use

The machine is for industrial use and has been designed for cutting off aluminium profiles. With a suitable saw blade and dust collection,
wood and hard plastic materials (PVC) may be machined also.
The workpiece must allow to safely be loaded, supported and clamped.
The machine is intended for indoor use. The protection rating of the electrical installation is IP 54.
If used for other purposes, JET disclaims any real or implied warranty and holds itself harmless from any injury that may result from that
use.
WARNING:
The machine is not suitable for cutting ferrous materials.
The machine is not suitable for cutting magnesium...high danger to fire!
The machine may not be used in explosive environments.

3.2 Remaining hazards

When using the machine according to regulations some remaining hazards may still exist.
Loss off compressed air supply can be hazardous.
Thrown workpieces and workpiece parts can lead to injury.
Dust and noise can be health hazards. Be sure to wear personal protection gear such as safety goggles and dust mask.
Use a suitable dust collection system.
The sawblade could be ejected if wrongly fitted. Therefore pay attention when fitting the saw blade.
The use of incorrect mains supply or a damaged power cord can lead to injuries caused by electricity.
When opening the electrical cabinet, the grid-feeding voltage persists. Therefore pay attention every time you enter it.
6