Print From Computer; Print From Computer (Wifi Connection) - FLASHFORGE 3D PRINTER Guider IIS Series User Manual

7.2.1 Print from Computer (USB cable connection)
① Connect your Guider IIS series with your PC via a USB cable.(Please
refer to 6.2.13 )
②Turn on your
③ Click [Print] and transfer your Gcode file to your
completing transference,
heating finishes, the print will start to build the model.
④When your PC connects with FlashPrint successfully. The status box on
the bottom right displays the real-time nozzle temperature. After finishing
preheating, your Guider Ⅱ starts the print job directly.

7.2.2 Print from Computer (WiFi connection)

Connect your Guider Ⅱ S with your PC via WiFi. (2 WiFi connection
①
methods, Please refer to 6.2.13 )
Enter into the IP Address shown on your Guider IIS series interface and
then click [Connect].
Guider IIS series User Guide | www.flashforge.com
Guider IIS, level the build plate and load the filament.
the printer will heat up automatically. And when
Guider IIS. After