Joy Sport CT SUPERIEUR User Manual page 25

7. Upper swing bar & lower swing bar
Take the right upper swing bar (12) close to the
right lower swing bar (94). Then combine the
hand pulse wire 1 out of the upper swing bar
with the hand pulse 3 out of the lower swing
bar.
Fix the right upper swing bar onto the right
lower swing bar. Insert through an inner
hexagon M8*36 screw and use M8*6.35T nylon
cap (9) to lock them up.
Then combine swing bar front housing (12) with
the swing bar rear housing (14). Use M4*35
round cross screw to fix them
NOTE: The left upper swing bar & left lower
swing bar (18) assembly process is completely
the same as right ones. Please refer to the
points above.
8. Meter.
First remove the four M5*10 screws for fixing
computer (44) on the back side of the meter
(43).
Combine the computer connecting upper wire
(53) with the meter wire on back of the meter;
connect the hand pulse wire 3 (54) & the hand
pulse wire 4 (55) with the hand pulse wire port
on back side of the meter.
Fix the computer on top of the computer post
and use the removed screws to lock it up.
45
17
15
9. Round Bar
56
Please firstly remove the inner hexagon M8*25
screws (45), M8 spring washer (17) and
OD20*ID8.5*2.0T flat washer (15) which are pre-
assembled on the round bar (56).
Attach the round bar (56) on the computer post
plate and use the removed the washers & screws
to lock them up.
9
5
7
9
14
8
55
12
13
18
43
44
54 55 53
92
7
9
6
54
14
12
13
13
94