Meter Assembly - Joy Sport CT SUPERIEUR User Manual

5 Meter assembly

First please remove two M8*68 inner
hexagon screws (48), two M8 nylon caps
(59), four M8 spring washers (17), two M8
arc washers (49), two M8*20 inner
hexagon screws (16) and two
OD20*ID8.5*2.0T flat washers (15) which
are pre-assembled at the bottom of the
computer post.
Slide the computer post lower cover (60)
onto the computer post (46) and keep it
on the upper position.
(Please refer to picture 5-A)
Move the computer post (46) with the
cover close to the main frame. Connect the
upper computer connecting wire (53) with
the lower computer connecting wire (53).
Fix the computer post (46) on to the main
frame. Use the removed parts to lock this
joint place tight.
Finally fix the computer post lower cover
onto the frame.
18
25
29
19
21
23
22
24
30
25
6 Lower swing bar & pedal tube
First use the inner hexagon spanner &
Tum spanner to remove the M10*78 inner
hexagon screw (22), OD20*ID10.5*2.0T
(23), lower swing bar axle (21) and M10
nylon cap (19) which are pre-assembled
on the L&R pedals (30,96).
Insert the lower swing bar axle (21) into
94
the inner bushing tube of the lower swing
25
29
bar (18)
22
23
Fix the left lower swing bar (18) with axle
into the U shape plate at the front end of
21
the left pedal tube (30). Insert through
19
24
the OD20*ID10.5*2.0T flat washer (23)
96
with the removed M10*78 inner hexagon
screws (22). Finally use M10 nylon cap
(19) to lock them tight
M4*20 round cross screw (25) to lock L&R
pedal tube covers (24,29) on this joint
place of lower swing bar and pedal tube.
NOTE: The right lower swing bar (94) and
right pedal tube (96) assembly process is
completely the same as the left ones. Please
refer to points as above.
8
48
17
49
15
15
16
59
17
53 53
60
61
Picture 5-A
Use the