Siemens SINAMIC G130 Operating Instructions Manual page 26

Mechanical installation
3.3 Installing the Braking Module
5. Insert the Braking Module where the cover used to be and secure it using the 3 screws
(from step 4).
6. Secure the connecting cable to the DC link with 2 screws (Braking Module connection)
and 2 nuts (DC-link connection).
Carry out the subsequent steps in reverse order from steps 1 – 3.
An opening above the connections for the braking resistor (R1, R2) is provided in the cover
for connecting the cable to the braking resistor.
Note
Pay attention to the tightening torques
You must observe the tightening torques. Information on this can be found in the table in the
"Mechanical installation" section
24
Braking Module / braking resistor
Operating Instructions, 11/2017, A5E00331454A