10.2.4
Rx / Tx/PTT switch
10.2.5
Speaker / Radio / Load switch
Tait Orca portables
TM8100 radios with
user interface
80
TOPA-SV-024 Test Unit
This 2-way toggle switch is used to switch between receive and transmit mode.
When set to Rx, the PTT line is switched to high impedance.
I
When set to Tx/PTT, the PTT line is pulled to ground.
I
This 3-way toggle switch is used during receive audio tests to switch the audio
to the test unit speaker (Speaker), to the radio's internal speaker (Radio) or to
a dummy load consisting of R1 and R2 (Load).
Note
This switch does not disconnect the radio's internal speaker on
M8100 radios with a user interface. If the switch is set to Speaker
or Load, this simulates an external speaker being connected in par-
allel to the radio's internal speaker. TM8100 radios without a user
interface do not have an internal speaker.
With all settings, a low level audio signal is available for testing through
the SINAD port.
When set to Speaker, only the speaker of the test unit is active.
I
When set to Radio, only the speaker of the Tait Orca portable is active.
I
When set to Load, no speaker is active. The audio signal is terminated in
I
the test unit dummy load.
When set to Speaker, the speakers of the test unit and the TM8100 are
I
both active. The speaker of the TM8100 cannot be disconnected.
When set to Radio, only the speaker of the TM8100 is active.
I
When set to Load, the TM8100 speaker remains active.
I
TM8000 Mobile Radio Accessories Manual
March 2004 © Tait Electronics Limited