Radio Programming - Tait TM8000 Series Accessories Manual

5.2

Radio Programming

52 TMAA02-06 Support Kit for Concealed & Dynamic Microphones
Important
To maintain the IP54 protection class, great care must be
taken when installing the microphone capsule and seal
into the concealed-microphone cavity.
3. Push the microphone capsule and seal
into the concealed-microphone
cavity, with the capsule wires
towards the speaker grille
4. Reassemble the control head. This
includes reinstalling the speaker
the space frame
i
head PCB .
Plug the speaker lead into the speaker
j
connector .
5. On the control head PCB, solder the positive concealed-microphone
wire to the MIC+ pad
Note
The positive wire on the microphone capsule is identified by a red stripe.
g
6. On the control head PCB, remove R11
1#
solder P2 and P3
1%
7. Plug S2 and S3
dynamic microphone support board onto P2
and P3 on the control head PCB.
8. Re-install the control head on the radio body.
When the support kit for concealed and dynamic microphones is installed
in a radio, two fields in the UI Preferences form of the TM8000
Programming Application may need to be selected.
Dynamic Mic Support: select this field if a dynamic microphone is
I
installed. An example of an accessory that uses a dynamic microphone is
the TMAA10-02 handset.
Covert Mic Fitted: select this field if a concealed microphone is installed.
I
Refer to the online help of the programming application for more information.
e
f
.
g
,
h
and the control
1)
and the negative wire to AGND
h i j
1) 1!
1$
in the positions shown.
1^
on the concealed and
TM8000 Mobile Radio Accessories Manual
March 2004 © Tait Electronics Limited
e f d
1!
1#
1@ 1$
1@
and
1%
1^
d
.