Changing The Machine Type (Only Via Display Module) - Bomag BW 219 DH-4 Service Training

BEM, BOMAG Evib Meter
Service Training MESX

6.3 Changing the machine type (only via display module)

For simple checking the currently adjusted machine type is displayed for approx. 3 seconds on the
display module of the central electrics when switching the ignition on. It can also be checked at any
time by entering code 7000.
Setting the machine type requires the following sequence:
Note: Parameter adjustments can only be performed when the engine is not running!
Enter code number 7 0 1 0 . This code number activates the function "Adjusting machine type".
The display module now permanently shows the code 7 0 1 0 .
Select and enter the machine from the table above.
The display module now permanently shows the entered code. (e.g. 7 5 3 3 )
Enter code number 7 0 1 1 . This code number confirms the entered machine type.
After confirming the machine type the control initiates a restart, the display module shows the new
machine type for approx. 3 seconds.
Switch the ignition off and on again.
After this the newly adjusted machine type will be displayed for approx. 3 seconds.
Attention: A machine must not be operated with a wrong type setting, because in such a
case the correct function of the control cannot be assured!
New controls are delivered with a default machine type setting 7 5 0 0 .
Status: 21.12.2011
Author: T.Löw / TE
008 924 62
Functions of the ESX control
BOMAG
6.2
Page 15 of 69
223