Table of Contents
Advertisement
Figure 57. Replacing the air baffle in a stand-alone system
Preparing the system for operation after removing and replacing an internal RDX power cable in the
9009-41A, 9009-42A, or 9223-42H
To prepare the system for operation after removing and replacing an internal RDX power cable, complete
the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Replace the service access cover.
For a rack-mounted system, complete the following steps. Refer to Figure 58 on page 68.
a. Slide the cover (A) onto the system unit.
b. Close the release latch (B) by pushing it in the direction shown.
RDX docking stations, removable disk drives, and power cable, for the 9009-41A, 9009-42A, or 9223-42H 67
Advertisement
Table of Contents
