IBM Power Systems RDX Manual page 56

Figure 35. Removing the internal RDX docking station from a stand-alone system
Replacing an internal RDX docking station in the 9009-41A, 9009-42A, or 9223-42H
To replace an internal RDX docking station, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the internal RDX docking station from the static-protective package.
3. Locate the RDX Air Block, part number 01GY504 in the FRU kit. Remove the adhesive protective cover
and apply the Air Block to the rear of the internal RDX docking station.
4. Align the internal RDX latch with the holes on the bottom of the internal RDX docking station.
5. Hold the internal RDX latch in place while sliding the internal RDX docking station into the system.
6. Slide the internal RDX docking station into the system until it locks into place as shown in Figure 36 on
page 43.
42 Power Systems: RDX docking stations, power cable, and removable disk drives for the 9009-41A, 9009-42A,
or 9223-42H