IBM Power Systems RDX Manual page 78

Figure 54. Disconnecting the internal RDX power cable
Replacing an internal RDX power cable in the 9009-41A, 9009-42A, or 9223-42H
To replace an internal RDX power cable, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Connect the internal RDX power cable (B) to the disk drive backplane. Ensure that the latch (C) on the
RDX power cable is oriented upwards for a rack-mounted system; and to the outside for a stand-alone
system. Connect the other end of the internal RDX power cable to the internal RDX docking station (A)
until it clicks into place as shown in Figure 55 on page 65.
64 Power Systems: RDX docking stations, power cable, and removable disk drives for the 9009-41A, 9009-42A,
or 9223-42H