IBM Power Systems RDX Manual page 50

Figure 29. Removing the service access cover
Removing an internal RDX docking station in the 9009-41A, 9009-42A, or 9223-42H
To remove an internal RDX docking station in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. For a rack-mounted system, lift the air baffle (A) straight up as shown in Figure 30 on page 37.
For a stand-alone system, remove the air baffle (A) straight out as shown in Figure 31 on page 38.
Place the air baffle upside down on a clean area so that the foam does not collect contaminants.
36 Power Systems: RDX docking stations, power cable, and removable disk drives for the 9009-41A, 9009-42A,
or 9223-42H