Blade Tensioning - Winco KATTEX TTS-188 Manual

Tension on the blades must be restored following each disassembly for cleaning or replacement of the
blade assembly.
WARNING: THE BLADES ARE VERY SHARP.
PLEASE USE CAUTION WHEN HANDLING
Note: The blade assembly can be installed only one way
with the longer offset facing up.
1. Be sure blade holder is firmly mounted on the Tomato
Slicer blase and the sharp side of the blades is facing
toward the pusher assembly.
2. Attach hex screws and washers and tighen evenly.
3. To check the blade tightness, wear a thick protective glove
and pluck or strum the back (unsharpened) side of the
blades until the blades "hum". Gradually tighten the top
and bottom hex screws until the top and bottom blades
sound about the same when plucked or strummed.
6

BLADE TENSIONING

This
side
faces
up