Advertisement
Quick Links
How to fit Micro Receiver DT20 to Cochlear™ Baha® BP100 and BP 110 Power
Required parts
1. Micro Receiver DT20
2. Programme DT20
3. Cochlear™ Baha®
Before fitting Micro Receiver DT20 to Cochlear Baha® BP100 or BP110
Please ensure that each step below is carefully followed before making any attempt to connect Micro Receiver
DT20 to the Sound processor.
1.
Preparing the Micro Receiver DT20
In this step you are asked to use the Step-By-Step guide in the Programmer DT20 in order to configure the
Micro Receiver DT20 for an optimal usage with Phonak iCom.
a. Turn on the Programmer DT20 and attach the Micro Receiver DT20 into its Euro-plug.
b. Select the Step-By Step menu
c. Select whether the DT20 is fitted to the right
or to the left ear
.
d. Skip the Scan instruction animation and scroll to the next step by pressing
e. Check that the Comfort Digisystem Michrophone is turned off.
On Programmer DT20 select
f. In this step the radio environment will
automatically be scanned by the DT20
Programmer´s built-in spectrum analyser
and the value of the radio interferences
will be presented on the screen ❶.
Ensure that there are no radio interferences
in your radio environment, before you go to the next step.
Green colour indicates acceptable radio interference level.
If any radio interferences higher than -91 dBm are indicated in your radio environment, you need to find the interference sources and
eliminate them.
g. There is no need to scan Cochlear Baha 100/110, due to
low radio interference from these devices.
Press
to go to the next step.
h. In this step ❷select
press
.
i.
Select
and press
j.
Select
and press
k. Turn on your Comfort Digisystem Microphone
and configure it with an appropriate radio channel.
On Programmer DT20 select
.
and press
❶
and
❷
.
.
and press
2
.
.
.
3
1
Advertisement
Related Manuals for Cochlear Micro Receiver DT20
Summary of Contents for Cochlear Micro Receiver DT20
- Page 1 In this step you are asked to use the Step-By-Step guide in the Programmer DT20 in order to configure the Micro Receiver DT20 for an optimal usage with Phonak iCom. a. Turn on the Programmer DT20 and attach the Micro Receiver DT20 into its Euro-plug. b. Select the Step-By Step menu c.
- Page 2 DAI. In other programs the audio signal from the internal microphone and the DAI will be mixed. Cochlear Baha® BP100 or BP110 can be configured for Mic relative DAI setting. The audio signal from DAI will be increased by +6 dB compared to the audio signal from the sound processor´s internal microphone.
- Page 3 If needed, manually adjust the volume control on the sound processor in order to obtain an optimal volume level. Select the DAI program on the sound processor and attach Micro Receiver DT20 into the sound processor´s DAI port. Micro Receiver DT20 will automatically be detected.