Cochlear Nucleus 6 User Manual

Wireless Pairing & Streaming – Cochlear
Microphones
Note: When bimodal pairing, first ensure hearing devices are programmed to opposite ears.
1.
Turn off ReSound hearing aid and
Cochlear Nucleus 6 Processor
TV Streamers
1.
Plug power and audio cables into TV
Streamer and connect to audio source
Microphones and TV Streamers
1. 2.
Turn on ReSound Turn on
hearing aid then microphone or
Nucleus 6 Processor turn on TV
2.
Turn on microphone
Note: Ensure microphone
is charged.
Switch on
2.
Turn off ReSound hearing
aid and Nucleus 6
OPTION
A.
Nucleus 6 Processor
Long-press the upper
Streaming to
button on your sound
one or both
processor once.
hearing devices
OPTION
Note: Streaming
A.
must be started and
Press and hold the push
stopped on each
device individually.
button on your ReSound
Hearing Aid for 3 seconds.
Nucleus 6 and ReSound
™ ®
3.
Locate and press the pairing
button on back by the clip
Note: The LED will flash yellow
while device is in pairing mode
for 20 seconds.
3.
Press pairing button
Note: The LED will flash yellow
while device is in pairing mode
for 20 seconds.
OPTION
B.
CR210 Remote Control
Long-press the Telecoil
button. Audio will start
streaming through the
microphone.
OPTION
B.
Using ReSound Unite Remote
If you have a ReSound Unite™ Remote
Control (optional), simply press the
streaming button on this Remote Control.
Maximize your hearing with both ears
4.
Turn on ReSound hearing
20
aid, pause 2 seconds, then
seconds turn on Nucleus 6 Processor
Note: The LED will flash blue to
show pairing was successful.
4.
Turn on ReSound hearing
20
aid, pause 2 seconds, then
seconds
turn on Nucleus 6 Processor
Note: The LED will flash blue to
show pairing was successful.
OPTION
C.
Using CR230
Remote Assistant
Long-press the
Telecoil button.
Wolfe, Jace. "Why Two Are Better Than One." Presented at ACIA 2014, Nashville, TN.
1
1