BRANNSTROM BilgMon488 Instruction Manual page 34

Steps:
1. Initial screen is shown (see Illustration 12: Initial screen, waiting for connection). The
program is now waiting for a USB-connection.
2. Connect the BilgMon488 to your PC using the USB-cable. Note that the the bilge alarm
does not need to be connected to a power supply since it gets power from the USB-cable.
The connected bilge alarm will show up last in the "Ports:" list.
3. Choose the latest appearing port from the list.
4. Click the "Start listening"-button. A dialogue will appear where you can choose an output
folder for the downloaded result.
5. The software is now listening for data from BilgMon488 (see Illustration 13: Connected
(VCP3) and listening).
6. On your BilgMon488 navigate to the log-menu and step in to the log. When exiting the log
you will be asked if you want to send the log. Answer yes and choose the amount of data to
download (see Illustration 14: Send log data from Bilgmon488). While the data is sent it will
show up in the "Received data" section of the log receiver.
7. When the download is finished the filename and position of the result can be found in the
"Status:" list (see Illustration 15: Log data download completed).
8. Close the application.
BilgMon488 Instruction Manual vAD 34(38)
BRANNSTROM SWEDEN AB
www.brannstrom.se