Force Automatic Stopping Device Activation - BRANNSTROM BilgMon488 Instruction Manual

10.6 F
ORCE AUTOMATIC STOPPING DEVICE ACTIVATION
When the separator is running and the PPM value is below 15.0 ppm the automatic stopping device
can be temporarily activated by pressing and holding
After 10 seconds or on a press of
returns to normal operation.
10.7 A
CKNOWLEDGE ALARM
If separator is running (separator status input is closed, BilgMon488 in ACTIVE mode) and the PPM
value goes above 15.0 ppm the unit will generate an alarm2 (alarm2 output terminal and LED). The
alarm2 can be acknowledged
terminal will be put in no alarm position but the alarm LED on the front will still be lit.
4
Automatic stopping device output cannot be acknowledged (only alarm2 output).
BilgMon488
2
4
by pressing ,
BRANNSTROM SWEDEN AB
www.brannstrom.se
BilgMon488 Instruction Manual vAD 19(38)
for approx. 2 sec.
Force valve
close: 10s
or . This means that the alarm2 output
EXIT