Maintenance - BRANNSTROM BilgMon488 Instruction Manual

BilgMon488 Instruction Manual vAD 29(38)
15 M
AINTENANCE
The BilgMon488 can be set to autoflush (see 10.11.3 Autoflush feature (automatic freshwater
cleaning)). This means that the sensor tube is flushed with clean water at durations and intervals as
set in the settings menu. Autoflush is only active when in main menu and BilgeMon488 is not active.
Cleaning the measurement unit should be done using a soft bottle-brush and mild detergent. Note
that there is a glass tube inside the SENSOR unit so don't use anything that might scratch or damage
the glass (i.e. metal objects). If the glass tube is layered with rust or similar try using low
concentrated acid (for example hydrochloric acid). Rinse well and make sure you protect your eyes,
skin and airways if using acidic substances.
Check the expiry date of the factory issued calibration certificate (9.2 Calibration certificate expiry
date).
BRANNSTROM SWEDEN AB
www.brannstrom.se