Accessories - VWR Mini Shaker Series Instruction Manual

a
( ' )
ccessorIes
cont d
uNivErSAL HArNESS
M
IcroPlate
d c
escrIPtIon aPacIty
Universal Harness 2 or 4
installation of universal Harness - Mini Shaker
1. Unit should be in standby mode.
2. Remove non-skid rubber mat.
3. Insert one band through the side of one "U" in the U-shaped cut-outs on the center
post. Pull band through to secure to the U-shaped cut-out. Repeat for the three
remaining bands.
4. After the bands are installed in the center post, line up the holes in center post with
the two holes in middle of the tray. Using the screws provided, hand tighten into
place using a flat-head screwdriver. DO NOT over tighten.
5. Place samples(s) on tray.
6. Stretch the harness bands over the sample(s) and then under each of the bent-
down corners of the tray.
Not for use with the Microplate Shaker.
13
P
latforM
c c . n .
aPacIty at o
1 444-0277
uNivErSAL PLAtFOrM
The Universal Platform has a non-skid rubber surface with adjustable clamping bars to
accommodate various vessel types. Stainless steel construction.
d s
escrIPtIon Ize
Universal Platform 29,7 x 22,1cm
installation of universal Platform - Mini Shaker
1. Unit should be in standby mode.
2. Remove non-skid rubber mat.
3. Line up the holes in the Universal Platform to the holes in the tray. Using
the screws provided, hand tighten into place using a flathead screwdriver.
dO NOt over tighten.
4. Add glassware. Adjust rollers by loosening each of the thumbscrews. Slide
the padded rollers to the desired position and retighten the thumbscrews.
Not for use with the Microplate Shaker.
P
latforM
(l W) c
x aPacIty
1
EN
c . n .
at o
444-0282