Usb Copy; Management Mode; Typical Setup Procedure - Thecus IP Storage Server N8800 User Manual

System Fan2
CPU Fan
2006/06/16 12:00
Disk Info
RAID
The N8800 will rotate these messages every one-two seconds on the LCD display.

USB Copy

The USB Copy function enables you to copy files stored on USB devices such as
USB disks and digital cameras to the N8800 with a press of a button. To use USB
copy, follow the steps below:
1. Plug your USB device into an available USB port on the Front Panel.
2. In Display Mode, press the Down Button (▼).
3. The LCD will display "USB Copy?"
4. Press Enter (
the front USB port.
5. All of data will be copied into system folder named "USBcopy".

Management Mode

During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
prompt will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is "0000". If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item
WAN Setting
LAN Setting
Link Agg. Setting
Change Admin Passwd
Reset to Default
Exit
NOTE

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your N8800 for
use on your network. Setting up the N8800 typically follows the five steps
outlined below.
For more on how to use the Web Administration Interface, see Chapter 4:
System Management >
Current system fan 2 status.
Current CPU fan status
Current system time.
Current status of disk slot has been installedh
Current RAID status.
↵
) and the N8800 will start copying USB disks connected to
Description
IP address and netmask of your WAN ports.
IP address and netmask of your LAN ports.
Select Load Balance or Failover. (N8800 only)
Change administrator's password for LCD operation.
Reset system to factory defaults.
Exit Management Mode and return to Display Mode.
You can also change your LCD password using the Web Administration
Interface by navigating to System > Administrator Password. For
more on the Web Administration Interface, see Chapter 4: System
Management.
Web Administration
↵)
and an "Enter Password"
Interface.
18