Igniter And Flame Sensor Assembly - L.B. White Premier TS170 Owner's Manual And Instructions

IGNITER AND FLAME SENSOR ASSEMBLY

1. The igniter and sensor assembly is located at the top
of the burner casting. See Fig. 17 or 18 depending
on heater model.
2. Remove the two screws securing the mounting
bracket to the burner.Remove igniter assembly.
3. Disconnect high voltage cable from igniter assembly.
4. Remove the two screws that secure the igniter sensor
to the mounting bracket.
5. To assemble, reverse above procedure.
FIG. 17
TS170
1/2 IN. DISTANCE FROM IGNITER
TOP TO BURNER TOP
HIGH VOLTAGE IGNITION LEAD
FIG. 18
TS080
MOUNTING BRACKET
1 1/2 IN. DISTANCE FROM
IGNITER TO "V" OF
BURNER CASTING
IGNITER BRACKET
MOUNTING SCREWS
17
FRONT VIEW
MOUNTING BRACKET
IGNITER BRACKET
MOUNTING SCREWS
IGNITER/SENSOR MOUNTING SCREWS
FRONT VIEW
IGNITER/SENSOR
MOUNTING SCREWS
ATTENTION
■
The igniter and ground rod should be cleaned to
maintain proper ignition.
-- Use steel wool or emery cloth.
-- Rub briskly to remove buildup of dust, dirt ,
and oxide.
■
Check the igniter's ceramic base for cracks.
-- Replace the igniter if cracks are found.
TOP VIEW
ELECTRODE GAP IS 1/8" &
CENTERED OVER BURNER PORT
TOP VIEW
ELECTRODE GAP IS1/8" & CENTERED
OVER BURNER PORT
BURNER PORT
BURNER PORT