Sediment Trap Assembly Instructions; Hose & Regulator Assembly - L.B. White 346JX Owner's Manual And Instructions

Assemble the tee, nipples and cap together and tighten
securely. See Fig. 6. The sediment trap assembly must
always be mounted in a vertical position. Make sure pipe
thread compound that is resistant to both propane gas and
natural gas is used in making all connections. Check a a ll
connections f f or g g as l l eaks u u sing a a pproved g g as l l eak
detectors.
1. Always use approved pipe thread compound suitable
for use with propane gas or natural gas on the
threaded connections.
2. Assemble the components together according to the
figure. This view is to show general assembly of the
components only.
mounted so its vent, regardless of location on the
regulator, is always pointed downward.
3. Tighten all connections securely.
4. Check a a ll c c onnections f f or g g as l l eaks u u sing a a pproved
gas l l eak d d etectors.
The regulator must always be
SEDIMENT TRAP ASSEMBLY
FIG. 6
NIPPLE
TO GAS CONTROL
VALVE INLET
MANUAL SHUT-OFF VALVE, HOSE
AND REGULATOR ASSEMBLY
FIG. 7
REGULATOR VENT
TO CONTROL
VALVE INLET
HOSE ADAPTER
TEE
NIPPLE
CAP
REGULATOR
NIPPLE
VALVE, MANUAL
SHUT-OFF
GAS HOSE
ADAPTER
SEDIMENT TRAP
13