Unit Diffuser Assembly; End Diffuser Assembly - L.B. White Premier TS170 Owner's Manual And Instructions

Tent heaters

Hide thumbs Also See for Premier TS170:

Owner's manual and instructions (141 pages)

Owner's manual (34 pages)

Owner's manual and instructions (7 pages)

Table Of Contents

Table of Contents

1. Insert the tabs of the diffuser into the vertical slots at

the blower outlet. Push down on diffuser to secure

into place. See Fig. 9.

2. Tent side wall material may be layed within channel

of the dif fuser to give a finished look to the

installation. See below for typical installation.

100 POUND L.P. GAS

SUPPLY CYLINDER

OR GREATER

(REGULATOR VENT

MUST POINT DOWN)

1. Insert collar into duct. Tabs of collar must be facing

away from duct. See Fig. 10.

2. Wrap the duct clamp around duct and collar. Saddle

of clamp lays over duct coil. Connect clamp ends

together and tighten securely. See Fig. 10.

FIG. 10

CLAMP

FIG. 9

TENT SIDE WALL

TENT DRAPED OVER

DIFFUSER CHANNEL

DIFFUSER

3. Insert tabs of collar into slots at air inlet of diffuser.

Push down to lock in place.

4. Tent side wall material may be layed within channel

of the dif fuser to give a finished look to the

installation. See Fig. 11 for typical installation.

FIG. 11