Conduct M9302A Self Test; Conduct M9302A Operational Check (Optional) - Agilent Technologies M9302A Startup Manual

Step 5: Verify Operation of the M9302A Module
Agilent M9302A Installed Drivers

Conduct M9302A Self Test

The purpose of the self test is to verify power and perform an internal check of module sub-components.

Conduct M9302A Operational Check (optional)

Requirements for Operational Check
The Agilent M9302A PXI Local Oscillator operational check measures the LO OUT signal and uses that as a ref-
erence to compare the signal paths to the 10 MHz REF OUT and the two 100 MHz REF OUT connectors. The fol-
lowing process demonstrates that all associated connectors, cables and circuitry are operational.
Required Hardware
To demonstrate that the module works properly requires external equipment. You will not be using the module
interconnect cables, so some high-quality flexible 3.5 mm cables will be required, plus adaptors to connect the
PSG (precision signal generator) and power sensors to 3.5 mm connectors. Please refer to the following table for
recommended hardware.
18 Agilent M9302A PXI Local Oscillator Startup Guide