Loading The Knx Application Program - Siemens LOGO! 8 Manual

3 Commissioning
No.
3.
4.
3.4

Loading the KNX application program

The following requirements have to be met to load the KNX application:

The physical addresses "1.1.2" and "1.1.3" are freely available in your KNX
system.

A communication interface of the ETS has been defined.
(Menu bar: "ETS > Bus")

A bus connection with KNX participants has been established.
(e.g. via the USB interface)
The table below describes how to load the application program from the supplied
ETS5 project into the KNX devices.
Time Switch Function
Entry ID: 109745699, V1.0,
1. Select the interface of your PC.
2. Enter the destination IP address of the LOGO!.
Click "Test" to test the connection to LOGO!. When the connection is shown
3.
in green, you can communicate with the LOGO!. If the test fails, check the
physical network connection and the network settings (IP addresses need to
be clear and the participants need to be in the same subnet).
After a successful test, click on "OK" to transfer the program into the LOGO!.
4.
1
Confirm the operating mode switch of the LOGO! from "RUN" to "STOP" and
from "STOP" to "RUN" with "Yes" for each case.
04/2017
Action
25