2 Setup and description
Via the button (2) of the simulation bar from
message text window.
In the message text window
programmed message texts (1). To open the input field of a parameter in a
simulated message text, double-click on the parameter (2). Then, enter a new
value for the parameter (3).
Observe the functioning of the program with the changed parameters. If necessary,
change the current time in LOGO! Soft Comfort.
Figure 2-12: –Simulating a message text
Whether the signal "1" or "0" is switched at a connection line can be seen in the
color representation
signal "1" are, by default, displayed in red and the connection lines with signal "0" in
blue.
To simulate an active signal at input I1, for example, you click on the button (3) of
the simulation tab from
simulation is also possible with the function key, however, not with the flag.
Figure 2-13: Simulate input signal
Time Switch Function
Entry ID: 109745699,
V1.0,
(Figure
(Figure
2-13). In simulation mode, the connection lines with
Figure
2-11, or directly on the input block I1. The described
04/2017
Figure
2-11, you can open or close the
2-12), you can switch between the
14