Adjustments And Expansions; Enabling The Web Server And Changing The Password - Siemens LOGO! 8 Manual

5 Adjustments and expansions

Adjustments and expansions
5
5.1

Enabling the web server and changing the password

Table 5-1: Enabling the web server and changing the password
No.
1.
2.
3.
4.
5.
6.
Time Switch Function
Entry ID: 109745699, V1.0,
In LOGO! Soft Comfort in the menu tab under "Tools > Transfer", select the point
"Access control...".
In the "Interface" window, enter the target IP address of your LOGO! and click
"Test" to test the connection to the destination LOGO!.
If the test result is positive, the connection is shown in green. Then click "OK" to
confirm the connection to LOGO!.
If the test fails, check the physical network connection and the network settings.
IP addresses need to be clear and all participants need to be located in the same
subnet.
If LOGO! is in the "RUN" operating mode, confirm the switch to the "STOP"
operating mode with "Yes".
To activate the web server, tick the "Allow Web server access" checkbox
1.
under "Web server access".
2. Assign a new password and confirm it by entering it again.
Click on "Apply" to apply the changes to the LOGO!.
3.
Confirm the switch to the "RUN" operating mode with "Yes".
04/2017
Action
32