Siemens LOGO! 8 Manual page 19

2 Setup and description
Parameter: Channel "From KNX to LOGO!"
The following table shows how to establish a channel for the data exchange from
KNX to LOGO!.
Table 2-8: LOGO! CMK2000 parameters: Channel "From KNX to LOGO!"
No.
1.
2.
Time Switch Function
Entry ID: 109745699, V1.0,
In the list view of the parameter settings, select the tab of a freely available
channel (in this application example "Channel 2").
Set "From KNX to LOGO!" for the transmission direction.
1.
2. Select the KNX data type which is transmitted to LOGO!.
Select with which data type (in this application example "Digital flag") the
3.
KNX signal is interpreted in the LOGO!.
Select the address (in this application example "50") for the selected data
4.
type, in order to determine how you would like to use the KNX signal in the
LOGO! program.
5. Activate the monoflop function and set a monoflop time. This implements a
digital trigger from KNX towards LOGO! 8 as a signal with a defined period
(automatic reset).
04/2017
Action
1
2
3
4
5
19