Siemens LOGO! 8 Manual page 17

2 Setup and description
Parameter: General
In the general parameters, you determine, inter alia, the LOGO! base module with
which the signal and data exchange is to be performed.
Table 2-6: LOGO! CMK2000 - Editing general parameters
No.
In the parameter settings view, select the "General" tab.
1.
2. Make the following settings for the LOGO! CMK2000:
1.
2.
3.
4.
Time Switch Function
Entry ID: 109745699, V1.0,
Enter the IP address of your LOGO! base module.
Information on this matter can be found in the LOGO! Manual in chapter
3.8.1 "Configuring network settings":
https://support.industry.siemens.com/cs/ww/en/view/109741041/893568026
99
Enter an IP address for the LOGO! CMK2000.
Enter a subnet mask for the LOGO! CMK2000.
Enter a password for the web interface of the LOGO! CMK2000 (required
for firmware updates).
04/2017
Action
1
2
3
4
17