Initiating A Conference; Initiating A Conference From The Contacts Screen - Huawei TP1102 Series Administrator's Manual

HUAWEI TP1102 Telepresence
Administrator Guide
There are multiple methods for initiating a conference from the touch panel.



4.1 Initiating a Conference from the Contacts Screen

The contacts list stores site information. This saves time as you do not need to enter site
information every time you initiate a conference and prevents entry of incorrect IP addresses.
You can also search the Lightweight Directory Access Protocol (LDAP) server or eSpace
server for an LDAP site, eSpace site, or virtual conference room. This helps you quickly
select a site to initiate a conference.
Prerequisites
The touch panel has connected to the telepresence host.
The related site information has been saved to the contacts list of the telepresence host.
Context
Table 4-1
Issue 01 (2013-07-15)
4
If your telepresence system works with a 9 series Multipoint Control Units (MCU) and
the MCU's embedded GK is enabled: Register the codec with the GK on the codec web
interface. On the touch panel, tap
unified access number. Then follow IVR instructions to join or create a conference.
If your telepresence system supports PassCode: Access the touch panel home screen. In
Access Code and Meeting Passcode, enter the access number and password, which is
allocated by the service management center when you schedule a conference. Then tap
to join a conference.
If the access number allocated by the service management center is the same as the value of Default
access code under > Settings > Advanced Settings > Conference Settings, you can join the
conference by filling in Meeting Passcode only and tapping
describes the buttons on the contacts screen.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

Initiating a Conference

. On the displayed keypad screen, dial the
.
4 Initiating a Conference
25